Verify local laws and manufacturer guidance before coating any firearm parts
Disassemble the item completely
Remove all oils, grease, dirt, rust, and old finish
Degrease thoroughly with a proper solvent
Media blast the surface with clean aluminum oxide or approved blasting media
Blow off all dust and avoid touching the prepared surface with bare hands
Mask any areas that must not be coated
Mix Cerakote according to the product instructions
Strain the mixed coating before spraying
Spray thin, even coats with an HVLP spray gun or approved applicator
Allow proper flash time between coats if required
Hang or place the part in a dust-free curing area
Cure the coating at the temperature and time specified by the product instructions
Let the part cool completely before handling
Remove masking carefully
Reassemble the item
Inspect the finish for coverage, thickness, and defects
Use proper ventilation, respirator protection, gloves, and eye protection throughout the process