Disconnect the negative battery cable
Locate the crankshaft position sensor
Raise and support the vehicle if needed
Remove any covers, shields, or intake parts blocking access
Disconnect the sensor electrical connector
Remove the mounting bolt or bolts
Pull the sensor out carefully
Compare the old sensor with the new sensor
Clean the mounting area and sensor opening
Install the new sensor in the correct position
Tighten the mounting bolt or bolts to specification
Reconnect the electrical connector
Reinstall any removed covers, shields, or intake parts
Lower the vehicle if it was raised
Reconnect the negative battery cable
Start the engine and check for proper operation
Clear any diagnostic trouble codes if needed