Disconnect the negative battery cable
Locate the engine coolant temperature sensor
Allow the engine to cool completely
Place a drain pan under the radiator or sensor area
Drain enough coolant to lower the coolant level below the sensor
Disconnect the electrical connector from the sensor
Remove any retaining clip, bolt, or threaded sensor as required
Remove the old sensor
Compare the old sensor with the new sensor
Install the new sensor
Tighten the sensor to the specified torque
Reinstall the retaining clip or connector lock if equipped
Reconnect the electrical connector
Refill the cooling system with the correct coolant
Bleed air from the cooling system
Reconnect the negative battery cable
Start the engine and check for leaks
Verify proper temperature gauge or scan tool readings
Clear any diagnostic trouble codes if needed