Cut your design with Cricut vinyl and weed away the excess material
Cut a piece of transfer tape slightly larger than your design
Peel the backing from the transfer tape
Place the sticky side of the transfer tape over the weeded design
Burnish the transfer tape firmly with a scraper or credit card
Flip the design over and peel away the vinyl backing slowly
If any vinyl lifts, press the transfer tape back down and burnish again
Position the transferred design onto your project surface
Burnish the design onto the surface firmly
Peel the transfer tape back slowly at a sharp angle
Re-burnish any vinyl pieces that do not stick to the surface
Remove the transfer tape completely
Smooth down the vinyl to finish the application