Turn off the vehicle and remove the key
Wear gloves and safety glasses
Disconnect the negative battery cable first
Disconnect the positive battery cable second
Mix baking soda...
Turn off the vehicle and remove the key
Wear gloves and safety glasses
Disconnect the negative battery cable first
Disconnect the positive battery cable second
Inspect the cables...
Wash the headlights with car soap and water
Rinse off dirt and debris
Dry the headlights with a microfiber towel
Mask the surrounding paint with tape
Apply a...
Turn off the engine and let it cool
Locate the mass air flow sensor
Disconnect the negative battery terminal
Unplug the sensor electrical connector
Remove the sensor from...
Wash the headlight with soap and water
Dry it completely with a microfiber cloth
Mask the paint around the headlight with painter’s tape
Apply headlight cleaner or...
Disconnect the battery
Drain the fuel tank completely
Remove the fuel tank from the vehicle
Remove the fuel pump, sending unit, and any other fittings
Inspect the tank...
Make sure the engine is completely cool
Park the car on a level surface
Open the hood and locate the radiator or coolant reservoir
Check the coolant...
Locate the O2 sensor on the exhaust system
Inspect the sensor and wiring for damage, corrosion, or loose connections
Check for trouble codes with an OBD2...
Turn off the engine and disconnect the ignition coil connector
Set the multimeter to ohms
Check the primary resistance by placing the probes on the coil’s...
Start the engine and listen for ticking, tapping, hissing, or puffing sounds near the exhaust manifold, pipes, and joints
Check for visible soot or black...
Check for white exhaust smoke
Check for coolant loss with no visible leak
Check for overheating
Check for milky oil on the dipstick or oil cap
Check for...
Locate the crankshaft position sensor
Inspect the sensor and wiring for damage, corrosion, or loose connections
Check the sensor connector for bent pins or contamination
Verify the...
Park the vehicle on a level surface and let the engine cool completely
Open the hood and locate the coolant reservoir
Check the coolant level against...
Warm up the engine to operating temperature
Disable fuel and ignition systems
Remove all spark plugs
Open the throttle fully
Thread the compression gauge into the first cylinder
Crank...
Disconnect power to the solenoid
Locate the solenoid terminals
Inspect the solenoid for visible damage
Check wiring and connectors for corrosion or looseness
Set a multimeter to resistance...
Turn off the engine and disconnect the battery
Locate the ignition coil
Inspect the coil for cracks, burns, corrosion, or oil leaks
Check the coil connector and...