Gather supplies: correct engine oil, correct oil filter, new oil drain plug washer/gasket (if applicable), oil filter wrench (if needed), funnel, gloves, drain pan, shop towels/rags, and jack stands/ramps or a lift (if needed)
Park on a level surface and set the parking brake
Warm the engine briefly, then shut off
Locate the oil fill cap on top of the engine
Locate the oil drain plug on the oil pan
Place a drain pan under the drain plug
Remove the oil fill cap
Remove the drain plug using the correct socket/wrench
Allow oil to fully drain
Reinstall the drain plug with a new washer/gasket if required; tighten to the specified torque
Remove the old oil filter
Apply a thin film of new oil to the new filter’s gasket
Install the new oil filter by hand until the gasket contacts, then tighten per filter instructions (do not overtighten)
Add new oil through the fill opening using the correct quantity from the owner’s manual
Reinstall the oil fill cap
Start the engine for 30–60 seconds
Shut off the engine and check for leaks at the drain plug and oil filter
Wait a few minutes, then check the oil level with the dipstick
Add oil in small increments until the level is correct
Clean up spills and dispose of used oil and the old filter properly
Reset the oil life reminder/service indicator (if equipped)