Turn off the circuit breaker and verify power is off with a tester
Remove the switch and outlet cover plates
Identify the incoming hot, neutral, and ground wires
Connect the ground wires to the green ground screw on the switch and outlet
Connect the neutral wire to the silver terminal on the outlet
Connect the hot feed wire to the brass terminal on the outlet or to the switch common terminal, depending on the circuit
Run a jumper from the always-hot feed to the switch common if the switch controls the outlet or a separate light
Connect the switched hot wire from the switch to the light load wire
Connect the outlet hot terminal to constant hot if the outlet should stay always on
Connect the outlet hot terminal to the switched hot if the outlet should be controlled by the switch
Tighten all terminal screws securely
Fold wires neatly into the box
Mount the switch and outlet into the electrical box
Install the cover plates
Turn the breaker back on
Test the switch and outlet operation